FAQ : GATOR BINDING AGENTS

Gator Block Bond XP

Gator Stone Bond

Gator Rock Bond

Gator Block Bond XP

Ideally the temperature needs to be above 32°F (0°C) for 24 hours.
Alliance Gator Rubber, Paint and Tar Remover + can be used to clean up the glue as long as the glue has not dried.
The short answer is – that Alliance glues will glue most construction materials. Some plastics may not glue well, for anything else it is advisable to do a test.
Normally the bond of the glue is as good as the surface it is being used to glue. The surface to be bonded cannot be dirty or dusty during application. Our XP Xtra Performance are considered permanent bonds.

Two years. It must be stored inside. It should not be stored in hot areas

Note: they should be stored at above freezing temp.

The Gator Block Bond Xtra Performance is heat resistant up to 400°F (204°C), normally the parts of a BBQ that need to be glued do not get hotter than this – however check with the BBQ manufacturer on expected operating temperatures. It is for the surrounding of the fire pit not in the pit.

Use Gator Rubber, Paint and Tar Remover + also soak your hands in warm water and scrub with soap – wear plastic gloves to prevent this from happening.

This is best done before the glue dries, scrape or wipe off the excess glue, careful not to smear it over a greater area – then apply Alliance Rubber Paint and Tar Remover and wipe – continue to reapply until completely gone.

Gator Stone Bond

This is best done before the glue dries, scrape or wipe off the excess glue, careful not to smear it over a greater area – then apply Alliance Rubber Paint and Tar Remover and wipe – continue to reapply until completely gone.

Yes.

Gator Rock Bond

Yes, when mixed with the proper stone, as there will be voids between the stones, rock bond will be permeable. The binder in itself is not permeable.

The glossy appearance of the Rock Bond binder will fade over time. This does not cause any weakening of the bond and the gloss can be restored with an application of Wet Look Sealer.

It takes a full 24 to 48 hours to cure and depends on how thick a layer has been applied. It is very important that there be no rain for a least 24 hours. Open working time is about 20 minutes it will vary with temperature and humidity.

While the Rock Bond is still wet, you can use Alliance Gatorene, It can also be pressure washed off if it has not dried.